CARRIAGE DRIVE
J001/J003 6-26 SM
6.6.3 ENVELOPE SELECTOR
Move the envelope selector [A] to adjust:
• The gap between the print heads
• The surface of the paper on the transport belt.
Pushing the lever to the back moves the print heads slightly away from the
surfaces of thick paper and envelopes. This stops chaffing on the printing surface
and smearing the ink.
A cam operates when the envelope selector is set for printing on thick paper or
envelopes. This moves the guide rod to create a gap about 0.8 mm wider than the
gap for normal printing.
This lever should be forward and set for printing on normal paper.
G707D932.BMP
[A]
To Next Page
Loading...
