INSTALLATION PROCEDURE
J001/J003 1-12 SM
1.2.4 CONNECT THE POWER CORD
1. Remove the tape [A] and power cord [B] from the back of the printer.
2. Plug the power cord [C] into the power source.
3. Ground the power cord at the power source with the ground wire [D] attached
to the plug.
WARNING!
1. Always connect the printer to a correct power source.
2. Do not share the printers power source with another electrical device or
appliance.
3. Connect the power cord directly into the power source. Never use an
extension cord.
4. Never attempt to modify the power cord in any way.
5. Never put heavy objects on the power cord.
6. Make sure that the area around the power source is free of unwanted
things so you can remove the power cord quickly in case of an
emergency.
7. Make sure the power cord is not coiled or wrapped around any object.
The power cord can get excessive heat build up and could cause a fire if
it gets coiled.
8. Never handle the power cord with wet hands.
G707I914.BMP
G707I915.BMP
[A]
[B]
[C]
[D]
To Next Page
Loading...
