PREPARATION
J001/J003 1-2 SM
1.1.2 CHOOSING A LOCATION
1. Always install the machine in these areas:
• On a sturdy, level surface.
• Where it will not get damp.
2. Make sure the machine does not get exposed to these:
• Extreme changes from low to high temperatures, or high to low
temperatures.
• Cold or cool air from an air conditioner.
• Heat from a space heater.
3. Never install the machine in areas that get these:
• Dust, lint, or corrosive fumes in the air.
• Strong vibrations.
• Locations higher than 2,000 m (6,500 ft) above sea level.
4. Put the machine on a sturdy, level surface.
• Put a level on the machine in these areas:
• Front/back
• Left/right side.
• Make sure variations between the front/back and left/right level readings are
less than 2 degrees.
To Next Page
Loading...
