SP Tables
J007/J010/J011 5-20 SM
Set Threshold for Venting During Printing
2200 TH:PRG:HUM11 35% Humidity
2201 TH:PRG:HUM12 65% Humidity
Use this SP to set the threshold value in the humidity table switches to the table
for air venting during printing.
SP2200: Looks up the low humidity table (35%).
SP2201: Looks up the high humidity table (65%).
[0 to 100/0/1/
o
C.]
5.2.4 GROUP 3000
Adjust Printhead Gap for dpi
3000 GAP:300:H1:G:F Print Head 1: 300 dpi: 1st Pass
3001 GAP:300:H1:B:F Print Head 1: 300 dpi: 2nd Pass
3002 GAP:300:H2:B:F Print Head 2: 200 dpi: 2nd Pass
3003 GAP:300:H3:G:F Print Head 3: 300 dpi: 1st Pass
3004 GAP:300:H3:B:F Print Head 3: 300 dpi: 2nd Pass
3005 GAP:300:H4:G:F Print Head 4: 300 dpi: 1st Pass
3006 GAP:300:H4:B:F Print Head 4: 300 dpi: 2nd Pass
[-128 to +127/FA/1/count.]
3007 GAP:600:H1:G:F Print Head 1: 600 dpi: 1st Pass
3008 GAP:600:H1:B:F Print Head 1: 600 dpi: 2nd Pass
3009 GAP:600:H2:B:F Print Head 2: 200 dpi: 2nd Pass
3010 GAP:600:H3:G:F Print Head 3: 600 dpi: 1st Pass
3011 GAP:600:H3:B:F Print Head 3: 600 dpi: 2nd Pass
3012 GAP:600:H4:G:F Print Head 4: 600 dpi: 1st Pass
3013 GAP:600:H4:B:F Print Head 4: 600 dpi: 2nd Pass
Use this SP to adjust the print head gap for ６00 dpi printing.
[-128 to +127/FA/1/count.]
3014 GAP:1200:H1:G:F Print Head 1: 1200 dpi: 1st Pass
3015 GAP:1200:H1:B:F Print Head 1: 1200 dpi: 2nd Pass
3016 GAP:1200:H2:B:F Print Head 2: 200 dpi: 2nd Pass
3017 GAP:1200:H3:G:F Print Head 3: 1200 dpi: 1st Pass
To Next Page
Loading...
