SUMMARY OF PROCEDURES
SM 3-1 J001/J003
Replacement
Adjustment
3. REPLACEMENT AND ADJUSTMENT
3.1 SUMMARY OF PROCEDURES
Parts up to Level 3 can be replaced in the field. Parts in Level 4 or 5, however,
need special tools, so repair at the repair center is necessary.
Level 1: Very easy to identify cause of the problem and replace.
External Doors Removal
Paper Cassette Removal
Output tray Removal
Extension Tray Removal
Print Head Cleaning (Normal) Installation, Replacement
Print Head Cleaning (Full) Installation, Replacement
Level 2: Easy to identify cause of the problem and replace.
Operation Panel Replacement
Waste Ink Suction Unit (Maintenance Side) Replacement
Maintenance Unit Replacement
Reverse Guide Replacement
Ink Ejection Unit Replacement
Trailing Edge Sensor Replacement
Waste Tank Full Sensor Replacement
Bypass Set Sensor Replacement
Print cartridge Set SW Replacement
Duplex Unit Set Replacement
Duplex Unit Replacement
Extension Tray Replacement Replacement
Feed Roller Cleaning, Replacement
Transport Belt Cleaning, Replacement
Firmware Update
Level 3: Difficult to identify the cause of the problem, but easy to replace.
PSU Replacement
High Voltage Power Pack Replacement
Horizontal Motor Replacement
Horizontal Encoder Cleaning, Replacement
Ink Supply Pump Replacement
Air Release Solenoid Replacement
Vertical Encoder Sensor Replacement
COM Board Replacement
Vertical Encoder Cleaning, Replacement
Vertical Encoder Sensor Replacement
Level 4: Difficult to identify problem, easy to replace but requires National Reclamation Center
adjustment.
Vertical Encoder Replacement
Vertical Motor Replacement
Waste Ink Suction Unit
Feed Clutch
Relay Board
Level 5: Difficult to identify problem, difficult to replace, and requires National Reclamation Center
adjustments.
Carriage Unit Replacement
Transport Belt Replacement
Charge Roller Replacement
Paper Cassette Release Lever Replacement
Feed Roller Replacement
Leading Edge Sensor Replacement
Control Board Replacement
DRV Board Replacement
To Next Page
Loading...
