Preparation
J007/J010/J011 1-2 SM
2. Make sure the machine is never exposed to:
Extreme changes from low to high temperature or high to low temperature.
Cold or cool air directly from an air conditioner.
Heat from a space heater.
3. Never install the machine in areas near:
Dust, lint, or corrosive fumes.
Strong vibration.
4. Do not use the machine at any location higher than 2,000 m (6,500 ft) above sea level.
5. Set up and use the machine on a sturdy, level surface.
Place a carpenter's level on the machine front-to-back, and side-to-side and
confirm that it is level.
variations between the front/back and left/right level readings should be less than
2 degrees.
Required Software Environment
Software Windows 98, Window Me, Windows 2000, Windows XP, Windows 2003,
Window NT 4.0 or later
Hardware 80-100 MB of HDD space available
Limitations
These limitations apply to the use of this printer:
Ver. 4.0 or later is required for Windows NT.
Windows NT does not support a USB connection to the printer. Use a network
connection.
The USB connection is supported by Windows 98, Windows Me, Windows 2000,
Windows XP, Windows Server 2000.
USB connection with Windows 98 and Windows Me is limited to USB 1.1.
1.1.3 MINIMUM SPACE REQUIREMENTS
To Next Page
Loading...
