CLEANING PROCEDURES
SM 2-3 J001/J003
Preventive
Maintenance
2.3.2 MAINTENANCE UNIT
Suction Cap
1. Remove the maintenance unit. (3.4)
2. Turn the drive gear [A] of the maintenance motor to the right to raise the
suction cap.
3. Wrap the tip of screwdriver or similar tool [B] with a damp cloth.
4. Use the wrapped tip of the screwdriver to clean these:
• Inside the cap
• Around the cap to remove the hardened ink
Important: Always wrap the tip of the tool with a with a damp cloth. This will
prevent the suction cup from getting scratched. A scratched suction cap could
cause poor print jobs.
G707P902.BMP
G707P903.BMP
[A]
[B]
To Next Page
Loading...
