Ricoh J001 - High Voltage Power Supply Board; Main Control Board

Component Removal
SM 3-19 J007/J010/J011
J007/J010/
J011
4. Remove the PSU (
x4, x1)
3.4.4 HIGH VOLTAGE POWER SUPPLY BOARD
Remove:
 Right cover
 Top cover
 Front cover
1. Remove the HVPS cover [A] (
x4, (x4)
2. Remove the HVPS board (
x3)
 Press up gently as you pull if the bayonet is difficult to disconnect
3.4.5 MAIN CONTROL BOARD
Before replacing the control board and NVRAM together, you should always print a
System Summary, Service Summary, and Engine Summary Chart. You will need these
reports to do important settings after replacement.
 You will need these printouts to reference previous settings that may require
resetting.
To print the System Summary:
 Confirm that paper is loaded in the paper tray.
 Push [Menu].
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA