BASIC REMOVAL PROCEDURES
J001/J003 3-8 SM
3.2.7 FRONT COVER, LEFT COVER, RIGHT COVER
Preparation
Remove:
• Duplex Unit (3.2.1)
• Output tray (3.2.2)
• Paper cassette (3.2.3)
• Top cover (3.2.4)
Front Cover
1. Remove the screws of the front cover [1] ( x 1).
2. Disconnect front cover pawls [2].
3. Disconnect front cover pawls [3]
NOTE: You cannot see the pawls on the right side of the front cover. The
carriage inside the printer hides them. Pull out the right end slightly.
Then use the tip of a small screwdriver to disconnect them.
Left Cover
1. Disconnect the tab of the left cover [4].
2. Disconnect the bottom pawls [5] and remove the left cover at the time you
lower the left cover. Do this procedure slowly.
Right Cover
1. Disconnect the tab of the right cover [6].
2. Disconnect the bottom pawls [7] and remove the right cover at the time you
lower the right cover. Do this procedure slowly.
Important: Use high caution at the time you work to not break the envelope
selector [8].
G707R909.WMF
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
To Next Page
Loading...
