PAPER FEED, TRANSPORT, OUTPUT
SM 6-35 J001/J003
Detailed
Descriptions
6.7.8 CHARGE LEAK DETECTION
The printer checks for and detects charge leaks at these times:
• Immediately after the printer is turned on.
• When it gets a leak detection signal from the high voltage power pack at the time
of printer operation.
These happen when a charge leak gets detected:
• The voltage supply from the power pack [A] gets interrupted immediately
• The printer stops the current print job in progress.
• The carriage returns back to its home position.
• The print heads are capped. The printer cannot operate.
Do these to let the printer go back to normal operation:
• Turn the printer off and on.
• You must remove the cause of the leak.
G707D940.BMP
[A]
To Next Page
Loading...
