TROUBLESHOOTING
SM 13 J006
J006
Status Display
Status
Message Display
Paper Misfeed Paper Jam (Top cover)
Check the indicated part(s), then remove any jammed paper.
[Top Cover] Click [User Guide] for further information.
Paper Misfeed Paper Jam (Duplex Unit)
Check the indicated part(s), then remove any jammed paper.
[Duplex Unit] Click [User Guide] for further information.
Paper Misfeed Paper Jam (Paper Exit)
Check the indicated part(s), then remove any jammed paper.
[Paper Output Exit] Click [User Guide] for further information.
Paper in Bypass Paper in Bypass Tray at Start
of Job
Print(s) are left in the Bypass. Remove the print(s). When the
printer's [Resume] key lights up, insert a sheet face up. Click
[User Guide] for further information.
Out of Printable Temperature Range Temperature Out of Range –
Too Low
Room temperature is out of the printable temperature range.
Turn the power off, then on. Adjust the room temperature to a
suitable range and wait for a while before using the printer.
Click [User Guide] for further information.
Out of Printable Temperature Range Temperature Out of Range –
Too High
Room temperature is out of the printable temperature range.
Turn the power off, then on. Adjust the room temperature to a
suitable range and wait for a while before using the printer.
Click [User Guide] for further information.
Printer Error Engine Service Call
Turn the power off, then on. If this message appears again,
please call the service. Click [User Guide] for further
information. ERR***-*
Operational Ink Waste Tank Near Full
Internal unit replacement is now necessary. The printer will
stop functioning shortly. Please call the service. Click [User
Guide] for further information.
To Next Page
Loading...
