PREPARATION
J001/J003 1-6 SM
3. [Paper Feed] Key
To restart an interrupted print job
Press the [Paper Feed] key to start a print job again after you remove the cause of
an error (paper jam, for example). The [Cancel] key flashes or lights and stays in
this condition for errors. For more, see Section “4. Troubleshooting”.
To feed a sheet manually
Set a sheet of paper in the bypass tray on top of the duplexer. Then press the
[Paper Feed] key at the time the software application prompts you to do so when
you manually feed paper.
To print a blank sheet (cleaning)
1. Press the [Power] key to switch the printer off.
2. Wait for the power LEDs to go off.
3. Press and hold down the [Paper Feed] key. Then press and hold down the
[Power] key for at least 3 seconds.
The ink level LEDs go on. Then one blank sheet is fed through the paper path.
Then the paper exits the printer.
4. [Cancel] key
Press the [Cancel] key to cancel a print job. This procedure erases all the data
from the printer memory.
To clean all the print heads
Press the [Cancel] key and hold it down for at least 3 seconds to make the [Power]
key flash. Then release it. The printer cleans all four print heads (Normal Cleaning).
To print a Nozzle Check Pattern
1. Press the [Power] key to turn the printer off.
2. Wait for the power LED to go off.
3. Press and hold down the [Cancel] key. Then press the [Power] key for at least
3 seconds. The four ink level LEDs go on. The printer prints the Nozzle Check
Pattern.
To Next Page
Loading...
