Cleaning Procedures
SM 3-37 J007/J010/J011
J007/J010/
J011
4. First, use a cloth [E] soaked in alcohol to wipe clean the surface of the transport
belt.
5. Use a dry cloth to wipe the belt.
6. Turn the feed guide [F] to rotate the transport belt and expose the next area of
the belt.
7. Repeat Steps 4 to 6 until the entire surface of the belt is clean.
8. Make sure that the entire surface of the belt is completely dry.
Water on the surface of the transport belt could interfere with the operation of
the printer.
To Next Page
Loading...
