Image Correction
J007/J010/J011 4-30 SM
4. Select "5007" and push [#Enter].
5. When you see "WASHING" push [#Execute].
6. Open the ink cartridge cover, remove the ink cartridges, replace them with the
cleaning cartridges, and close the ink cartridge cover.
7. Confirm that "WASHING" and "EXEC" are still displayed, then push [#Enter].
8. When you see "OK?" push [#Enter].
"RUNNING" displays while the cleaning sequence executes.
When cleaning is finished, the display returns to "WASHING" and "EXEC"
If the "Alert" lamp lights red, this indicates that an error has occurred. At this
step you cannot see the error displayed on the printer operation panel.
Complete the procedure to return to standby mode, read the number of the
error displayed to determine the cause of the error.
9. Press [Escape] to return to the "2. ENGINE MAINTE." display.
10. Select "3. END" and push [#Enter] to return to standby.
11. Switch the printer off.
12. Remove the cleaning cartridges and store the printer.
The initial ink fill counter resets at the end of washing. The next time the ink
cartridges are installed and the printer is switched on, the initial filling sequence
will begin.
Do not install the ink cartridges and turn the printer on again after washing until
you are ready to use or service the printer again.
To Next Page
Loading...
