EasyManua.ls Logo

Ricoh J001 - Page 448

Ricoh J001
670 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SP Tables
SM 5-13 J007/J010/J011
J007/J010
J011
Use this SP to set the pitch width of the charge applied to the MID area on the
2nd side of glossy paper for duplex printing in the High Quality mode. Do this SP
when mist build-up in the MID area on the 2nd side of glossy paper is causing
the print heads to clog during duplex printing in High Quality mode. This SP
setting is linked to the charge pitch tables (SP1200 to SP1231).
The IDs are determined by the temperature and humidity. There are 4 IDs
associated with the SP numbers listed below:
SP1157ID1
SP1159ID2
SP1161ID3
SP1163ID4
[0 to 255/0/1/0.1 mm]
Calibrate Humidity/Temperature for Duplex
1164 HUMI:B Calibrate Humidity Setting for Duplex
Use this SP to calibrate the temperature/humidity sensor for humidity readings
during duplex printing. Do this SP to update the charge pitch table for duplex
printing. This SP setting is linked to the humidity steps in the charge pitch tables
(SP1200 to SP1231).
[-128 to +127/0/1/0.1%]
1165 TEMP:B Calibrate Temperature Setting for Duplex
Use this SP to calibrate the temperature readings for duplex printing. Do this SP
to update the charge pitch table for duplex printing. This SP setting is linked to
the temperature steps in the charge pitch tables (SP1200 to SP1231).
[-128 to +127/0/1/0.1%]
Charge ID Tables: Mj1
1200 CHG:PITCH:A1 Mj1: Less Than 10% Lookup Table
1201 CHG:PITCH:A2
Mj1: 10% 25% Lookup Table
1202 CHG:PITCH:A3
Mj1: 25% 35% Lookup Table
1203 CHG:PITCH:A4
Mj1: 35% 45% Lookup Table
1204 CHG:PITCH:A5
Mj1: 45% 55% Lookup Table
1205 CHG:PITCH:A6
Mj1: 55% 65% Lookup Table
1206 CHG:PITCH:A7
Mj1: 65% 75% Lookup Table
1207 CHG:PITCH:A8 Mj1: More than 75% Lookup Table
Use this SP to configure the charge ID table for printing on normal paper in High
Speed (Draft) mode. Do this SP when mist build-up on the paper in use is
clogging the print head nozzles.
This setting is linked to the charge pitch settings (SP1100 to 1107, SP1133 to
1139).
[0 to 0xffff ffff/0/1/---]
For more details, please refer to Section 4 "Transport Belt Charge Adjustments".
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA

Table of Contents

Related product manuals