Electrical Component Functions
J007/J010/J011 6-44 SM
No. Component Function
Print Heads
PH Print Head 1
J007/J010: Contains 2 ink tanks: K, C.
J011: Contains 2 ink tanks: Y, M
PH Print Head 2
J007/J010: Contains 2 ink tanks: M, Y
J011: Contains 1 ink tank: K
PH Print Head 3
J007/J010: None
J011: Contains 1 ink tank: C
PH Print Head 4
J007/J010: None
J011: Contains 2 ink tanks: M, Y
Sensors
SN
1st Registration
Sensor
Attached to the left side of the carriage. As the
carriage moves from side to side during printing.
The registration sensor performs two important
functions for print control: 1) It detects the leading
edge of every sheet, and 2) it detects the width of the
1st sheet of every print job when the carriage and
sensor pass horizontally over the vertical edge of the
1st sheet as it feeds.
SN
2nd Registration
Sensor
Located in the center of the printer above the transport
belt and behind the horizontal motor timing belt. This
photosensor detects the leading and trailing edge of
each sheet when the printer is printing at high speed.
These readings are used to control job timing and to
detect paper jams.
SN Air Sensors
A pair of vertical pins at the top of each ink tank. This
pair of pins detects changes in the voltage differential
on the surface of the ink inside the print head tank.
When these terminals detect air in the tank, this
actuates the air release solenoid and vents air from
the tank through the air release valve. This allows
more ink to enter the tank.
SN
Carriage Position
Sensor
Mounted under the right, front corner of the top cover.
Detects the position of the carriage and print heads
above the paper. When the envelope selector is pulled
forward, the feeler leaves the gap and switches the
sensor off. This mechanism is used to detect the up
and down position of the carriage and print heads.
SN
Ink Cartridge Set
Switches
A microswitch for each ink cartridge connected in
series and mounted on the ink cartridge detection
plate at the back of the right front cover that holds the
ink cartridges. A metal contact on the back of the ink
cartridge makes contact with the microswitch when the
ink cartridge is inserted. This tells the machine
To Next Page
Loading...
