J007/J010/J011 58 Repair Center Manual
If the "Alert" lamp lights red, this indicates that an error has occurred. At
this step you cannot see the error displayed on the printer operation panel.
Complete the procedure to return to standby mode, read the number of the
error displayed to determine the cause of the error.
9. Press [Escape] to return to the "2. ENGINE MAINTE." display.
10. Select "3. END" and push [#Enter] to return to standby.
11. Switch the printer off.
12. Remove the cleaning cartridges and store the printer.
The initial ink fill counter resets at the end of washing. The next time the ink
cartridges are installed and the printer is switched on, the initial filling sequence will
begin.
Do not install the ink cartridges and turn the printer on again after washing until you
are ready to use or service the printer again.
13. Remove the ink collection tank from the back of the printer and discard it.
14. Insert a new ink collection tank.
15. To reset the software counter for the new ink collection tank, depress:
[Menu]-[System]-[Ink CU Replace]
⇒
Rev. 02/2007
To Next Page
Loading...
