WASTE INK UNIT
J001/J003 3-14 SM
4. Disconnect the full sensor [A] of the
waste ink tank.
5. Raise the waste ink suction unit [B]
above the boss [C] on the frame. Then
pull it out of the printer.
Reinstallation
• Insert the waste ink unit from the top.
• Keep the ink supply tubes pressed against the printer frame at the time you
insert the waste ink unit. Make sure the tubes are not tangled or disconnected.
• Make sure the rear tab on the back of the waste ink unit fits into the slot of the
printer frame. The hole of the front tab will not align with the hole below if the rear
tab is not inserted correctly.
G707R919.BMP
[A]
[B]
[C]
To Next Page
Loading...
