connection set point time, the x-Messenger voice system will stop dialing and cease to broadcast the voice
message. The x-Messenger will then redial automatically according to the settings in the "Sms message
output block.
2. User must enter a # before entering the password. The broadcasting will then stop
and the user should enter a four-digit password within 10 seconds. If the user fails to
enter the password, the x-Messenger will re-broadcast the voice prompt. The user
must then enter # first and then enter the password. If the user needs to enter the
password again, the procedure needs to be repeated. That is to say that every time
the user needs to enter the password, he must enter a # first and enter a four-digit password
within 10 seconds after the voice has stopped.
3. When the user has entered the correct password, the voice system will broadcast
section 2-Correct password. Please enter the control code to control and then
the user can do the following operation. If the password is wrong, the voice system
will broadcast section 3-Wrong password. Please re-enter. The user can only enter
the wrong password three times. If the user enters the wrong password for a fourth time , x-Messenger will
hang up the telephone and stop broadcasting. If the alarm status still exists, the voice system will dial
automatically, for alarm purposes, every 40 seconds.
4. When the alarm status exists, x-Messenger will broadcast the alarm voice
repeatedly. It can be stopped by the use of the control function within the program.
5.
For the first time set-up, before recording, the user must delete existing messages before. Otherwise the recorded voice
may be lost. As to the recorded voice messages, user may delete or modify randomly the voice message in
them. And it has no effect on the other voice messages. As for the details, it is explained in the voice
recording
explanation.
To Next Page
Loading...
