218 Rockwell Automation Publication 2080-UM002M-EN-E - April 2022
Chapter 10 Controller Security
controllers, or the 2080-REMLCD for Micro820 controllers. Then,
ControlFLASH™ can be used to update the controller firmware, which also
clears the controller memory. In Connected Components Workbench software
version 10 or later, the Reset option must be selected for the controller memory
to be cleared during the firmware update. If the Upgrade or Downgrade option
is selected, the password is retained.
Using the Memory Module
Plug-in
You can use the memory module (2080-MEMBAK-RTC and 2080-MEMBAK-
RTC2) to download a program into different controllers.
Back up the project
To perform a project backup from a controller to the memory module, follow
these steps:
1. Create a new program and choose the desired controller.
The Micro850 controller is used for this example.
2. Double-click the controller icon under Project Organizer to bring up the
controller properties window.
3. Add the memory module to the first slot in the controller.
ATTENTION: The project in the controller will be lost but a new project can be
downloaded.
IMPORTANT
2080-MEMBAK-RTC is not supported on Micro850 (2080-L50E) and
Micro870 controllers.
To Next Page
Loading...
Need help?
General
