220 Rockwell Automation Publication 2080-UM002M-EN-E - April 2022
Chapter 10 Controller Security
Settings. Select Yes to download the program into the controller. A
window should pop up stating that the operation has been completed
successfully.
Using the Memory Module to Copy a Project to Multiple Controllers
You can use the memory module to download a project to multiple controllers
without connecting them to a PC with Connected Components Workbench
software installed. To do this:
1. Back up a project with “Load Always” option enabled.
2. Remove the module and plug it into a different controller.
3. Cycle the power. Observe the Status LED on the module lights up for a
few seconds while the project is being downloaded from the module to
the controller.
4. When the operation is finished you can unplug the module and leave the
slot empty, or plug in a different MEMBAK-RTC module if you want to
use the RTC functionality.
To Next Page
Loading...
Need help?
General
