User Interface
R&S
®
GP-E/GP-S
44User Manual v16.2.1 ─ 01
3. Under "Max Hops" , enter the maximum number of nodes (routers or other devices)
to be traversed on the way to the destination. The default number is set to 30, but
you can enter any integer from 1 to 255. If the destination is not reached before
this threshold, probe packets are discarded.
4. Click "Run" to start tracerouting.
The list of gateways traversed along the way is shown in the console area under "Out-
put" .
3.4.1.7 System
Use the options under "System" to reboot your gateprotect Firewall, reset the system
configuration, revert to a previous version or shut down the firewall. You can also
determine the host name of your gateprotect Firewall, set the system date and time
and specify your time zone.
System Actions
Under "Firewall > System > System Actions" , you can reboot or shut down the firewall,
reset its configuration or revert to a previous version.
The following actions are available on the panel that opens:
Field Description
"Reboot Firewall" Restart the system without changing any settings. The currently installed firm-
ware version is used and the current configuration is reloaded.
"Reset to factory
defaults"
Restore the original configuration from the time of system delivery and log out
the current user. This command does not change the current gateprotect Fire-
wall system firmware.
"Revert to previous ver-
sion"
Restart the system with the previously used firmware version. This can be used
in case a system upgrade was successfully installed but is not working properly.
To be able to execute any of these actions, you need to provide your login "Pass-
word" .
The buttons at the bottom right of the panel allow you to perform the chosen action
( "Confirm" ) or to reject the execution of the action ( "Cancel" ).
Notifications
The "Notifications" settings determine which events trigger notification messages to the
administrator.
You can activate notifications for the events listed in the table. To enable notifications,
you need to specify the email addresses, server and transmission options that are
used to send messages.
Be sure to verify the settings before activating any notifications.
Menu Reference
To Next Page
Loading...