Roland V-Synth - Try out the Sounds; Selecting Patches and Playing Sounds

26
Try Out the Sounds
Selecting Patches and Playing Sounds
The V-Synth comes with a wide range of onboard sounds, including single tones
called patches . Let’s select a few patches to get an idea of the variety of sounds
available with the V-Synth.
1
Make sure the PATCH PLAY screen is displayed.
If the PATCH PLAY screen—shown below—is not displayed, press [EXIT] once or
twice until the PATCH PLAY screen appears.
fig.Q-06.e
2
Play the keyboard to hear what the selected patch sounds like.
3
To change to a different patch, touch the patch number to highlight it,
and then turn the VALUE dial or press [INC/+] [DEC/-]. At this time you
can switch more rapidly by holding down [SHIFT] while you perform
these operations.
fig.Q-06a
Patch number
Alternately, you can touch the
patch number and drag your
finger up and down—or right
and left—to change patches.
For details on the factory-set
patches in the V-Synth’s
memory, refer to “Sound List”
(separate booklet).
Reference_e.book 26 ページ ２００５年３月１０日 木曜日 午後５時６分