Roxell FLEX-AUGER FA 75 - GENERAL SAFETY RULES FOR INSTALLATION

ROXELL - 031 - 0516
FLEX-AUGER - INSTALLATION INSTRUCTIONS
III-1
1. Be CAREFUL when handling the ROLLS OF AUGER.
- When you release the BINDING WIRE, it is possible that the auger UNROLLS.
This can cause injuries.
- ALWAYS use SAFETY GLOVES when you slide the auger into the tube.
- ALWAYSsee that the auger CANNOT SPRINGBACK (by using clamps) when
you put it under tension or couple it .
2. Check all ELBOW and TUBE CONNECTIONS and all TUBE CLAMPS on control
unit, boot and bearings for PROPER CLAMPING. Tighten all tube clamps with a
TORQUE of min. : 10Nm.
3. Take care to provide SOLID SUSPENSION POINTS. Each suspension point
should be able to hold MIN. 50kg .
4. At the FIRST START UP, make sure that, if the auger HITCHES or BLOCKS,you
can IMMEDIATELY SWITCH OFF the system with the main switch on the control
panel.
GENERAL S AFETY RULES
Carefully read the following instructions before
you
INSTALLthe system
IMPORTANT
DANGER
ThisSYMBOL willbeusedtodrawyour attentiontomattersthat
are of GREAT IMPORTANCE for your SAFETY.
It means :
WARNING - follow the safety instructions :
disconnect the current - re-read the safety rules.
Inshort:
BEALERT.IGNORINGtheseinstructionscancause
SERIOUS INJURIES or even DEATH.