10 Introduction SPS-2000 Program Manual v1.30
Unbox & Install MCR
1. Carefully remove the SPS-2000 from the shipping container.
2. Locate and unwrap the magnetic card reader MCR.
3. Remove the two Phillips head screws securing the MCR port cover at the upper-right corner of the
screen.
4. Locate the male end of the 7-wire connector at the ECR.
5. Connect the MCR female 7-wire connector to the ECR male 7-wire connector.
6. Carefully tuck the connector and wire into the ECR and attach the MCR with the two threaded screws
provided.
Power Requirements
Plug the SPS-2000 into a grounded 3-prong outlet.
The SAM4s SPS-2000 is a modern computerized network system. As with all network systems, it requires
appropriate electrical power wiring and proper routing of communication cabling for reliable operation and
maximizing the life of the equipment.
When installed in a merchant location, CRS recommends a PowerVar ABC065-11 power conditioner, CRS
P/N 701002, which will support an SPS-2000 ECR and printer. An uninterruptible power supply (UPS) is
recommended where frequent power disruptions occur. Without a UPS, the SPS-2000 will shut down and
reboot when power is disrupted. (The SPS-2000 reboots in less than one minute.)
CRS also recommends:
1. Dedicated branch circuits for SPS-2000 equipment.
2. Isolated Grounding for all equipment within the SPS-2000 system.
Please refer to the SPS-2000 Installation Guide for detailed power requirements.
To Next Page
Loading...
Need help?
General
