SPS-2000 Program Manual v1.30 Introduction 11
ECR Controls & Connections
Front Panel Angle Adjustment
Standard
Magnetic Card
Reader (MCR)
Front Panel Power Button
Press and hold the Front Panel
Power Button to alternately shut
down or activate the touch panel.
ote that the main power switch is
located on the bottom of the ECR
in the right-rear corner. The front
anel power button may be
enabled or disabled in the S-Mode
options program.
Set the position of the front
anel support to adjust the
angle of the front panel
from 22° to 77°.
The Error light
will flash
during IRC
compunctions’
To Next Page
Loading...
Need help?
General
