SPS-2000 Program Manual v1.30 P Mode Programming 79
PLU Add & Change
1. From the PGM mode PROGRAMMING MENU touch PLU to view the PLU program selection
window.
2. Touch PLU ADD & CHANGE to view the SELECT PLU screen.
3. You can edit existing PLUs in one of two ways:
Touch a PLU key located on the MAIN SCREEN, or touch PAGE UP/PAGE DOWN until the
appropriate Key Link where you wish to edit a PLU displays. (Note: Beginning at v3.00c you can
touch a modifier key, the a PLU.)
Enter the PLU number and touch OK.
You can add new PLUs in one of two ways:
New PLUs that are to be located the MAIN SCREEN or a Key Link must first be assigned to a key
location in S mode. Once a new PLU is assigned to a screen, touch the key to add the PLU descriptor
and options.
PLUs can be randomly added by entering a PLU number and touching OK, or by scanning an item if
a scanner is connected.
To Next Page
Loading...
