SPS-2000 Program Manual v1.30 Introduction 9
Introduction
SAM4s SPS-2000 Overview
Hardware
The SPS-2000 features a 12.1” color LCD touch screen and many popular off-the-shelf POS peripherals can
be connected by way of serial communication ports. The SPS-2000 has no hard disk drive, instead running
its built-in application software from on-board flash memory and storing data on non-volatile RAM.
Equipped with an LCD touch screen, the SPS-2000 resembles in appearance and application a PC-based POS
terminal. However, unlike open-architecture PC-based terminals, the SPS-2000 cannot run other PC
applications – it is only capable of running the bundled, built-in POS application.
Software
The built-in SPS-2000 POS application has considerable flexibility and can be configured for both retail sales
and food sales in quick and table service environments.
Like ECR programs, the SPS-2000 application program allows the reseller to configure the terminal to
perform in a specific setting. After consulting with the merchant, the reseller uses S-Mode (secure) programs
set to memory allocation, system configurations, key functions and locations, port assignments, passwords
and other system settings. Then the P-Mode (program) is used to complete the end user program for the
merchant with, price look-up (PLU) programs, messages, employees, taxes, and other system options.
Options
Each SPS-2000 ECR is configured with all options included. Each SPS-2000 has maximum memory, a card
reader, SD memory card reader, and a rear display standard. No additional ECR options are available.
To Next Page
Loading...
