SPS-2000 Program Manual v1.30 P Mode Programming 99
Function Key
Function key options vary by key. A "Function Key Program Summary" on the following page lists each
function and its options.
Note: Although each 12 character function key descriptor is set here, if a function key appears on the
financial or employee report, the descriptor that prints on the report may be set separately. See “Messages”
on page 145to set descriptors on the financial or employee report. See “Report Printing Option Definitions”
on page 125 to determine which descriptors are used on reports.
1. Select FUNCTION KEY from the PGM Mode menu to display the SELECT FUNCTION KEY
Screen.
2. Select a function to program:
Enter the function key code and touch OK,
Or, use the PAGE UP/PAGE DOWN keys to view and touch the function key you wish to program.
The programming option screen for the function will display.
3. Refer to Function Key Programming Notes on page 104 if you need assistance with specific options.
To Next Page
Loading...
Need help?
General
