SPS-2000 Program Manual v1.30 Software Installation & SD Memory Utilities 29
E. Verify Software Version
After updating, verify the software version using the following procedures. If your ECR does not update,
reboot your PC and repeat the procedure from step A. Verify that you are using a crossover cable to connect
the ECR to the PC; do not use a LAN cable.
Application, Kernel & Ramdisk Versions
1. Touch the S Mode tab. Enter the password if required.
2. Touch SELF TEST.
3. Touch VERSION. The Version Screen displays:
Boot Version
1. Turn the Power Switch to the ON position while holding down the power button on the front panel
below the screen. The Boot Version displays:
To Next Page
Loading...
