SPS-2000 Program Manual v1.30 Appendix 179
Appendix
Report Function Key Report Code Structure
You can print out reports from the REG tab using the REPORT key. Reports are generated by first entering
the report code, then touching the REPORT key, i.e.:
[Report Code] [REPORT]
The REPORT key code is #36 and is available on software versions 2.00j or later.
Report Code Structure
010100
The report code example above “010100” generates an X1 Standalone Financial Report.
Report # Table
NO. REPORT NAME X/Z & REPORT LEVEL IRC
01 Financial X1 & Z1 also X5 to Z5 INDIVIDUAL & IRC
02 Sales by Time Period X1 & Z1 also X5 to Z5 INDIVIDUAL & IRC
03 All PLU’s X1 & Z1 also X5 to Z5 INDIVIDUAL & IRC
04 Not use this by REPORT key function.
05 PLU’s by Group X1 & Z1 also X5 to Z5 INDIVIDUAL & IRC
1. Enter the 2-digit report number. See the “Report Table” below.
2. Enter “0” for X reports; enter “1” for Z reports
3. Enter the report level: “1” through “5”
4. Enter “0” for standalone reports: enter “1” for IRC reports, (or “2’ to view
IRC for all registers without entering the IRC range with v.2.02b or later).
5. Enter the option code, 1-4 digits. See the “Report Option Table” below. If
no option is selected, enter “0”.
To Next Page
Loading...
Need help?
General
