34 Software Installation & SD Memory Utilities SPS-2000 Program Manual v1.30
Bootloader Upgrade from SD Card
Beginning at BootROM version 1.10, both bootloader and operating system files can be updated from the SD
card (not USB). Updates to ECRs with BootROM versions before version 1.10 must be done using the TFTP
server method.
NOTE: SD cards must be formatted as FAT 32. To avoid compatibility issues, CRS recommends that you
purchase SD cards from CRS.
1. Go to the SPS-2000 dealer support page of www.crs-usa.com
and download the zip file for the most
current complete software version. Unzip and locate the BootRom.bin file.
2. At your PC, create an “Update” folder on the root of the SD card. Copy the BootRom.bin file to this
folder. In Windows Explorer, your view should look similar to this:
3. Insert the SD card into the SPS-2000.
4. Power down the SPS-2000 (the main power switch is located on bottom of SPS-2000 in the right-rear
corner).
5. Hold front power button down.
6. Turn SPS-2000 main power switch ON while holding down front power button.
7. Touch [1][2][8][7] for system password.
8. Touch SYSTEM MENU.
9. Touch BOOT UPDATE - SD.
10. After updating is complete, turn the SPS-2000 power off.
11. Perform an All Clear
a. Power down the SPS-2000 (the main power switch is located on bottom of SPS-2000 in the
right-rear corner).
b. Hold front power button down.
c. Turn SPS-2000 main power switch ON while holding down front power button.
d. Touch [1][2][8][7] for system password.
e. Touch ALL CLEAR.
f. Touch YES when prompted “ALL CLEAR THE MACHINE?”.
g. The SPS-2000 will reboot.
h. Enter the station number after the station reboots: [1] OK.
To Next Page
Loading...
Need help?
General
