SPS-2000 Program Manual v1.30 Software Installation & SD Memory Utilities 19
Software Installation & SD
Memory Utilities
Overview
The latest software revisions will be posted on the SPS-2000 dealer support page of the CRS website:
www.crs-usa.com
. Software will be revised continually as anomalies are identified, repaired, and as new
features and peripherals are supported.
Always verify that the latest software is installed prior to preparing equipment for installation.
NOTE: Software pre-installed on new equipment may not be the latest version.
Monitor the CRS dealer page and your email for bulletins and software update information.
Verify that the same software version is installed on all terminals in a multi-terminal installation.
Important: Updating Existing Installations
If you are performing an update on an existing installation, remember that you must perform a memory all
clear after installing updated software. Before updating an existing installation:
1. Save memory allocation, programs and reports (S/SRAMBACKUP).
2. Perform updates as necessary.
3. Clear all memory from System Menu (power on holding front power button to access System Menu.)
4. Restore previously saved memory allocation, programs and reports (S/SRAMBACKUP). (Note:
occasional format changes may prevent reloading of certain programs and/or reports.)
To Next Page
Loading...
Need help?
General
