SPS-2000 Program Manual v1.30 Software Installation & SD Memory Utilities 33
5. The screen displays Update or Backup Complete. Click Close.
If you are completing an application backup, there will be a delay of about 3 minutes before the S-
MODE menu returns and the backup is complete. Do not power off the ECR or attempt another
operation until the S-Mode menu returns. After completion, it is not necessary to clear memory.
If you are completing application update, you must clear all memory.
6. To Perform an All Clear:
a. Power down the SPS-2000 (the main power switch is located on bottom of
SPS-2000 in the right-rear corner).
b. Hold front power button down.
c. Turn SPS-2000 main power switch ON while holding down front power
button.
d. Touch [1][2][8][7] for system password.
e. Touch ALL CLEAR.
f. Touch YES when prompted “ALL CLEAR THE MACHINE?”.
g. The SPS-2000 will reboot.
h. Enter the station number after the station reboots: [1] OK.
7. Verify the Application software version by pressing the X/TIME key in REG mode. The version
information will display.
To Next Page
Loading...
