SPS-2000 Program Manual v1.30 P Mode Programming 151
GALLON AMOUNT REQUIRED
This entry involves a gallonage PLU, and requires an amount entry.
HALO OVER!
The amount entered exceeds the programmed HALO i.e. the task exceeds the maximum amount allowed.
ILLEGAL KEY SEQUENCE
The operator has used an illegal key sequence.
IN USE!
This guest check or clerk number is already open elsewhere in the system. This is also applicable when
the floating clerk system is activated and the operator is in use on another ECR.
INACTIVE!
The key pressed is inactive. This message also appears if VOID Mode has been disabled.
INPUT QTY
Quantity input is required for a condiment WLU
KITCHEN PRINTER FAILURE
The kitchen printer has failed to respond. Printing has been re-routed to the designated back-up printer.
MANAGER OVERRIDE REQUIRED
Manager code entry required to override a HALO amount, or other restriction.
MANAGER REQUIRED
This operation requires entry of the manager code.
MEMORY FULL
Memory is full.
NEGATIVE
This sale has gone negative. Negative sales are programmed as not allowed.
NO CHECK #
This message appears when the system cannot find this guest check number.
NO DATA
PLU cannot be found (does not appear in Register Mode). Usually associated with stock entry on an IRC
system when the PLU exists in one ECR but not another. On the ECR where the PLU does not exist the
message not found will appear.
NO DRAWER!
The employee currently signed on is not assigned to a drawer, and is not allowed to perform cash sales, or
the drawer is no longer attached and is required in order to continue.
NO MANUAL ENTRY
Manual entry is not allowed (scale function).
NO PAPER
Slip printer is out of paper, appears when printing to a loose-leaf printer.
To Next Page
Loading...
