174 Program Guides SPS-2000 Program Manual v1.30
3. Program the EMPLOYEE CARD READ FORMAT.
FIELD Notes
READ
Set to the Track (1 or 2) that you wish to read.
CARD ID
If ID numbers are to be used, enter the ID number (up to 10 digits)
from the magnetic cards that will be accepted. If ID numbers are not
to be used, ignore this field.
CHECK CARD ID?
Enter Y to use card ID numbers, or N if you do not wish to use card
ID numbers.
COLUMN OF CARD ID
Enter the number of the column that the Card ID starts.
CARD ID DIGITS
Enter the number of digits to be read for the Card ID.
COLUMN OF NUMBER
Enter the number of the column that the Card number starts.
CARD NUMBER
DIGITS
Enter the number of digits to be read for the Card number.
To Next Page
Loading...
Need help?
General
