Sam4s SPS-2000 - Page 24

24  Software Installation & SD Memory Utilities SPS-2000 Program Manual v1.30
3. Select the Internet Protocol TCP/IP listing and click the Properties command button.
4. Click the “Use the following IP address” option button and enter the settings displayed in the example
above.
5. Click OK, and then click OK to close the Local Area Connection Properties dialog box.
CAUTION:
If you are changing
your normal network
settings to connect to
the SPS-2000, be sure
to restore your settings
after SPS-2000
Communications are
com
p
lete.