EasyManuals Logo

Sam4s SPS-2000 Program Reference Manual

Sam4s SPS-2000
195 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
66 S Mode Programming SPS-2000 Program Manual v1.30
(11) REG# HOLDS BACKUP CHECK TRACKING DATA
The four check-tracking files can backed up on a second ECR.
(12) REG# HOLDS KP GLOBAL ORDER#
The order number printed on kitchen order tickets can be the register number followed by a consecutive
number or can be held centrally and be a system consecutive number this is referred to as a global order
number.
(13) REG# HOLDS CLERK INTERRUPT DATA
Identify the register that stores transaction data when the transaction is suspended while another clerk
begins a different transaction.
(14) DISPLAY PRINTER ERROR WHEN POLLING
This controls the response of the ECR when a printer is not available to print a PC activated report. The
option is default to No to ensure that if a printer is off line the communications will continue.
(15) ENABLE FRONT POWER SWITCH
If Yes, the front power switch is activated. This front power switch blanks/disables the touch screen
without shutting down or re-booting the register.
(16) USE GRAPHIC TABLE MANAGEMENT
If Yes, Table Management is available. See “Table Management Program Guide” on page 160.
(17) NUMBER OF REGISTER THAT HOLDS THE DATATRAN
Enter the number of the ECR in the network where the DataTran is connected.
(18) MSR IS CONNECTED
Set MSR CONNECTED to DATATRAN if the MSR is connected to the DATATRAN; PDC if the MSR
is connected to the PDC; REGISTER if the MSR is connected to the register (internal).
(19) PINPAD IS CONNECTED
Select DATATRAN or PDC.
(20) PINPAD KEY TYPE
Set the PIN encryption method: DUKPT or ROTATE KEY.
(21) TRACK# HOLDS DELIVERY TABLE
If using a delivery system, indicate the tracking file number that will be used to keep transactions input
using the delivery function.
The following are used for sending reports via FTP:
# NETWORK SETTING?
Set to YES for FTP communications
AUTOMATICLLY GET IP ADDRESS? (DHCP)
Set to YES only if you want to get the OP address from the DHCP server. Consult your network
administrator.
IP ADDRESS
Set only for IP polling.
SUBET MASK
Set only for IP polling.

Table of Contents

Other manuals for Sam4s SPS-2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sam4s SPS-2000 and is the answer not in the manual?

Sam4s SPS-2000 Specifications

General IconGeneral
BrandSam4s
ModelSPS-2000
CategoryCash Register
LanguageEnglish

Related product manuals