120 Cubis MSA User Manual
Checkweighing
y The test results are displayed.
If the results are within tolerance, the weight results will always be displayed.
In addition, they appear in green on in the graphic scale.
If the results are outside of the tolerance, the weight results are displayed in red
(above maximum) or yellow (below minimum) on the graphic scale.
t To toggle the display to the check mode, touch %JGEM
y Now the display will show whether the upper limit (**) or the
lower limit (..) has been exceeded.
t To check additional objects, empty the weighing pan and place the next object
on it.
y The display is updated dynamically.
t You can toggle between weighing and checkweighing at any time by touching
9GKIJ or %JGEM
To Next Page
Loading...
Need help?
General