Sartorius MSA3.6P - Restoring Factory Settings; Installing the Motorized Draft Shield (Optional)

52 Cubis MSA User Manual
System Settings (Menu)
Restoring Factory Settings
You can reset all settings individually to the factory settings at any time.
t Use the cursor softkeys to navigate through the &GXKEGRCTCOGVGTU
submenu to 4GUVQTGHCEVQT[UGVVKPIU.
t Mark any settings you want to reset and select 0GZV.
t Confirm the reset when prompted.
Installing the Motorized Draft Shield (Optional)
O
On balances equipped with a motorized draft shield, the control unit has buttons
on the right and left sides. These buttons can be used for motor-driven opening
and closing of the draft shield doors. You can configure the functionality of these
keys in the menu.
Models with the analytical draft shield:
For example, you can configure the left key to open and close the right and upper
door (for right handers) and the right key to open and close the left door (for left
handers). The opening width (entirely or partially) of the sliding panels can also be
defined. You can configure these settings manually on the draft shield itself
(see “Learning Function” below).
t Check and correct all settings as required.
t To save settings, touch 5CXG.
t Define the functions for the left and right keys:
1HH: The keys have no function.
5COGHWPEVKQP: Both keys have identical functions.
*5GRCTCVGHWPEVKQPU: The left and right keys are configure with different
functions.