Cubis MSA User Manual 59
Task Management
Example: Creating a task
D
t Open Task Management and touch 'FKV.
y The list of options is displayed.
t To define a new task, touch %TGCVG.
y An application list is displayed.
t To view all applications, use the scroll bar on the right.
t Select the application you want to assign to the new task.
t Configure this application as required. The program guides you through the
configuration menu.
t If you want to assign additional applications to the task, these applications
should also be configured (see Combining Applications into One Task).
y After all applications for the new task have been configured, the following
parameters have to be set: Configure the settings for weighing and printouts.
All settings make here will only affect the new task.
On balances verified for use as legal measuring instruments, modification of some
settings may limited or prohibited altogether.
Settings for Weighing
t Check all settings and change as required.
Explanations for the individual options can be found in the chapter System Settings
in the section Device Parameters.
t Touch 0GZV.
Settings for Printouts
t Check all settings and change as required.
Explanations for individual options can be found in the System Settings chapter
in the Device Parameters section.
t Touch 0GZV.
t Enter a short name and a description for the new task.
t Touch 5CXG.
y The task selection list with the new task is displayed.
To Next Page
Loading...