Scanivalve MPS4232 - Page 9

3
MPS4232
Table of Contents
Table 5.3 - LabVIEW® Binary Packet (32 Chan) 37
Table 5.4 - LabVIEW® Binary Packet (64 Chan) 37
FTP File Names and Formats 37
Command Format 38
General Control Commands 39
Status 39
MPS Firmware Version 39
MPS Core Versions 39
Calibraon Version 40
Flash Directory Contents 40
Delete File 40
Load Conguraon File 40
File Contents 41
List 41
Save 42
Stop 42
Reboot 43
Format Flash 43
Read Current Temperature 43
Read Model 44
IP Variables 46
List IP Sengs (LIST IP) 46
Set IP Address of the MPS (IPADD) 46
Set Subnet of the MPS (SUBNET) 46
Set Physical Ethernet Address (MAC) 46
Set Gateway (GW) 47
Scan Variables 48
List Scan Sengs (LIST S) 48
Set Rate (RATE) 48
Set Frames Per Scan (FPS) 48
Set Scan Units (UNITS) 49
Set Scanning Data Format (FORMAT) 50
Set Trigger (TRIG) 50
Set Enable FTP (ENFTP) 51
Idencaon Variables 52
List Idencaon Sengs (LIST ID) 52
Set Serial Number (SN) 52
Set Nominal Pressure Range (NPR) 52
Set the Mulple Device Mulcast Address (MCAST) 52
Miscellaneous Variables 54
List Miscellaneous Sengs (LIST M) 54
Set Simulaon (SIM) 54
Set Echo (ECHO) 54
Set Excitaon (XITE) 54
Set Validaon Error Tolerance (ETOL) 55
FTP Variables (LIST FTP) 56
LIST FTP Sengs (LIST FTP) 56
Set User Name (USERFTP) 56
Set FTP Password (PASSFTP) 56
Set FTP IP Address (IPFTP) 57
Set FTP File Name (FILEFTP) 57
UDP Variables 58