To Next Page

To Previous Page

Table of Contents

1.0 Introduction 15

2.0 Working with the Fire Alarm Control Panel and the

Configurator 16

2.1 Connecting the Configurator to the Fire Alarm Control Panel ........................................ 16

2.1.1 Inserting the CodeMeter Key .......................................................................................... 17

2.1.2 Connecting the Computer ............................................................................................... 17

2.2 Sending a Job to the Fire Alarm Control Panel .............................................................. 18

2.3 Getting the Active Job from the Fire Alarm Control Panel .............................................. 19

2.4 Exporting a Job ............................................................................................................... 20

2.4.1 Exporting a job as a database file or an XML file ........................................................... 20

2.5 Managing Jobs ............................................................................................................... 20

2.6 Changing the Active Job ................................................................................................. 21

2.6.1 Changing the Active Job using the Fire Alarm Control Panel ......................................... 21

2.6.2 Changing the Active Job using the Configurator ............................................................ 22

2.7 Deleting a Job ................................................................................................................. 22

2.8 Getting Configuration Information ................................................................................... 22

2.8.1 Getting Configuration Information from the Configurator ................................................ 23

2.8.2 Getting Configuration Information from the Fire Alarm Control Panel ............................ 24

2.9 Getting Information about the CodeMeter Key ............................................................... 24

2.10 Restarting the Fire Alarm Control Panel ......................................................................... 25

2.10.1 Performing a Network Restart of the Fire Alarm Control Panel ...................................... 26

2.10.2 Performing a Network Restart of a Single CPU .............................................................. 26

2.10.3 Performing a Hard Restart of the Fire Alarm Control System ........................................ 26

2.11 Watchdog Jumpers ......................................................................................................... 27

3.0 Upgrading Firmware 29

3.1 Upgrading Firmware ....................................................................................................... 29

4.0 System Limits 32

4.1 MMX System Limits ........................................................................................................ 32

4.2 Frames ........................................................................................................................... 33

5.0 Advanced Logic 36

5.1 Overview of the Advanced Logic Editor .......................................................................... 36

5.1.1 Inputs List ....................................................................................................................... 37

5.1.2 Device Status ................................................................................................................. 38

Secutron MMX-2009-12NDS Application Guide

Other manuals for Secutron MMX-2009-12NDS