166
Using the Configurator
Dialer
To configure the dialer with the Configurator
1. Remove the RS-485 / UIMA cable from the MMX-2000N panel and plug it directly to the
dialer.
2. Short the jumper marked JW2 on the dialer.
3. Edit the dialer parameters, described above, and press the Send button.
4. Type your password.
19.12 Adding a Device
You can add input devices (for example, manual stations or smoke detectors) to a device loop.
To add a device
1. Select the loop that you want to add a device to.
2. Click Insert > Add Device.
Line Select the number of retries that you want the dialer to
make.
Rings You can program the dialer remotely over a phone line.
Select the number of rings before the dialer answers
when you call it.
Warning: If this is set to zero the next dial-in session will
not connect.
Mode Select DACT or UDACT. The UDACT mode includes
information about the zone when the dialer calls the
monitoring station.
Enable Unselect this check box if you want to set the dialer to the
disabled state when you send the job to the panel. The
dialer is enabled by default.
Aux disconnect The dialer blocks the alarm and supervisory events from
being reported after the auxiliary disconnect button is
pressed.
To Next Page
Loading...
Need help?
General
