41
Advanced Logic
5.2.1 Creating a zone
To create a zone
1. Select Input Zones (under Base I/O) in the job tree on the left side of the Configurator
window.
2. Click the Insert menu, and then click Add Zone.
The Add Zone window appears.
3. In the Process As pulldown menu, click Mon (monitor zone). Click Add to add the zone,
and then click Close.
4. Double-click in the Tag column, and then type a name for the zone, for instance,
Monitor Zone 1. Press the Enter key.
Tagging the zone helps you identify it when you create the equation.
5.2.2 Correlating the zone with an input using advanced logic
To correlate the zone with an input
1. Create two input devices, and then tag the devices appropriately. The tags help identify
the devices when you create the equation.
2. Click Monitor Zone 1.
3. Click the Advanced Logic tab at the bottom, and then click Edit.
The Advanced Logic Editor appears.
4. Click :A (alarm) in the Device Status menu.
5. Select the first input device, and then click the > button to move the device to the
Equation box.
6. Click the AND button.
7. Select the second input device, and then click the > button to move the device to the
Equation box.
The equation should look like this:
06-03-11-IN-101:A AND 06-03-11-IN-102:A
8. Type a description in the Description box, and then type a comment in the Comments
box.
9. Click OK to close the Advanced Logic Editor.
5.2.3 Correlating the zone with an output
To correlate the zone with an output
1. Right-click the zone, then click Add Correlations.
2. Add an output, and then click Close.
Monitor Zone 1 will become active when both devices become active. When Monitor
Zone 1 becomes active, its output correlations will also become active.
To Next Page
Loading...
Need help?
General
