24
Working with the Fire Alarm Control Panel and the Configurator
Figure 13 Advanced Panel Information
2.8.2 Getting Configuration Information from the Fire Alarm Control Panel
You can get configuration information from the FACP itself, including the number of the ESD
and technician that configured the FACP.
To get configuration information from the FACP
1. On the main display of any node or on an annunciator for any node in the system, press
the MENU button.
2. Use the arrow buttons to scroll to Config Info, and then press ENTER.
The display shows the ESDNo (ESD number) and TechNo (technician number).
3. Press the down arrow button to see the Build Time (the date and time when the firmware
on the CPU was built).
4. Press the down arrow button to see the IP information for this node (the IP address, the
subnet mask, and the default gateway).
2.9 Getting Information about the CodeMeter Key
To get information about the CodeMeter Key
1. Insert the CodeMeter key into the computer.
2. In the Configurator, click Panel, and then click Security Key Info.
Node The number assigned to each node.
CPU The number for each CPU on the node.
Type The type of CPU, for example a Main CPU, LCD Annuciator, Loop
Controller, or Audio Controller.
Version The version of the firmware on the CPU.
Language The language that the display uses for messages and menus.
Status The status should be Online.
Config Version
GUID
A number that uniquely identifies the active job on the FACP.
To Next Page
Loading...
Need help?
General
