F1 – Record Ready / Live
This option enables or disables the recording of notes while record mode is active.
Press the “recrd” soft-key, F1, to toggle the setting between “live” and “ready ”.
In pattern edit, you can always restore the pattern you are working on by exiting to play mode and
choosing to “lose” changes on the way.
So this option defaults to “live” for pattern edit record.
In play mode, there is no way to recover what was previously in a pattern once you have over-written
it.
So this option defaults to “ready ” in play mode and playlist edit.
This means input notes will not be recorded into the pattern, but you can audition what you are going
to record.
You must switch to “live” before any notes will be recorded, or before using the “del” soft-key.
F2 – MIDI Thru
When record is activated, incoming notes to be recorded are received on the record MIDI channel
configured using the “Thru conf” option on play mode page 7.
While record is active, notes on the record channel will not be passed through according to the normal
soft-thru settings.
Instead, if you enable the “mthru” option, notes arriving on the record channel will be passed through
on the output MIDI channel of the track being recorded.
This means you can automatically re-route the notes from your controller keyboard to whichever
instrument you are going to record a pattern for.
F3 – Delete
The “del” soft-key can be used to clear the current step as the pattern plays.
If you hold the key, all steps passed while the key is held will be cleared.
This lets you wipe out all or part of a bad take without having to clear the gate, tie and possibly aux
enable settings on each step.
To Next Page
Loading...
