Target Values For Grab, Swap and Push
Having looked at the grab event, the swap and push events should not be any great mystery.
Push does the same thing as grab, but in the opposite direction – the target value on the current track
replaces the value on the target track.
Swap essentially does a grab and a push at the same time – the target values on the current track and
target track are swapped.
You can experiment with the differences between these events quickly by re-assigning the auxes in
your example patterns. The pairs of step values for one event will work for the others.
Here is the full list of target values that can be acted on:
• note
• velo
• leng
• dlay
• gate
• tie
• X
• all (all pattern values are replaced)
• nte+A (current note value plus any accumulator offset)
• nte+P (current note value plus any playlist transpose)
• vel+A (current velocity value plus any accumulator offset)
• aux B
• aux C
• aux D
• xD+A (current aux D value plus any accumulator offset)
*TIP To quickly set all the steps in a pattern to the same value, so they all grab note from the same
track for example, use the Sculpt upper function described in the pattern edit chapter.
To Next Page
Loading...
