It’s important to remember that the playlists in each part just say which patterns should play on each
track – they don’t hold the patterns themselves.
So when you copy a part, the destination part will play the same patterns as the source part – the
patterns are not copied.
If you edit the patterns in a copied part, the altered patterns will play in any other part which uses
them.
For this reason, the “part-copy”, “active” function may be more commonly used, as this allows you to
create a new part with some tracks playing the same patterns as before, but other tracks playing new
patterns over the backing of the copied tracks.
To copy a part:
• hold the part-copy soft-key for “all” or “active”
• press the PART key for the destination part
Don't try to select a part chain while copying - it won't work.
As the newly copied part is selected, current part settings will also be saved in the part being copied.
*TIP Holding FUNC while performing a mute hold or part copy will copy the current settings to the
new part without saving recently changed settings in the source part.
To Next Page
Loading...
