SGM Technology for lighting GB
Pilot 3000 Us
er’s Manual 1.00
- 17 -
Load
Pushing the Load key, will load the Cue’s fixture parameters into the Editor. The command can
also be applied to Palettes and must be used every time a Cue or Palette modification is needed.
UPDATE
Pushing the UPDATE key, will store and update an already edited Cue. This command is used
after a Load Cue action.
PAGE
Allows changing the Registers Playback Page active to a new one. The Page changing is
performed by pushing the Page key and Playback key (1-20) corresponding to the desired page
Store
Pushing the STORE key, will store Cues, Palettes, Groups of fixtures.
SELECT
Pushing the SELECT key, will be possible to choose the active Register where to stor a Cue-List
or a Cue. When pushing this key, all the green LED of the Playback keys will ligh OFF except the
one related to the active Register which will start blinking. The Register sel ctio is performed by
pushing the SELECT key followed by the Playback key (1-20) corresponding o the desired
Register.
RELEASE
Pushing the RELEASE key, will literally release (turn off) the activ Playback Register and its
running cues. The Register Playback release action is performed b pushing the RELEASE key and
the requested Playback key. A multiple Register Playback r lease action at the same time, is also
possible by pushing twice in a row the RELEASE key. Th s w l turn off all the running Cues of the
active Cue-list (Black-Out!).
To Next Page
Loading...